Operating Guide

Figure 13b
LOG CRADLES
1. Align the holes on the left log cradle to the inside and lower holes
on the beam mounts. Insert the M12x35 bolts, flat washers, nuts
and securely tighten.
2. Follow step 1
to assemble the right log cradle. (See figure 14)
Figure 14
M12X35
xa MIM
YS2565PM02 -1703
Gas Log Splitter » Operator's Manual
LOG TABLE (OPTIONAL)
Refertofigures15aand 15bto install the worktable. Remove
the bolts, flat washers, and nuts from the inside holes. Move
the log cradle from the incline position to the horizontal
position. Align holes on the log cradle with the outside holes
on the beam mount. Reinstall bolts, flat washers, and nuts.
Figure 15a
Place the work table over the holes in the log cradle and align
the 4 holes from the work table plate and log cradle. Insert
and tighten the M10x25 bolts, spring washers, flat washers,
and nuts.
M10x25(x4)
~ --r--t--1(--++___,
~
Figure 15b
M10X25
X4 1111
Assembly I 18