Use and Care Manual

ASSEMBLY
This lawn mower was partially assembled at the factory. To assemble your machine follow the below instructions.
LOWER CONNECTING HANDLEBARS
1. Move the cutting height adjustment lever to the lowest position.
(See Figure 2, illustration 1)
2. Attach the short studs in the lower connecting handlebar into any
one
of the three holes in the handle bracket. Align the lower hole
in the lower connecting handlebar
with the hole in the bottom of
the handle bracket. Insert the bolts, washers, bushes and secure
with nuts. (See Figure 2, illustration 2)
~ NOTE
The three holes in the handle
bracket are for three different
handle heights. Quickly switch between the three
holes
by unlocking the knob, adjusting and then
releasing.
~®til@ ffi)
11 I Assembly
Lowest Cutting Height
Figure2
M8x35 X2
UPPER HANDLE
Align the holes in the upper handle and the holes in connecting
handlebars
to set a comfortable height position for the handle, then
secure and tighten by using carriage
bolts
and star shaped clamping
nuts knobs.
(See Figure 3)
Figure3
X2