Save This Manual for Future Reference YARDMAX~ Walk-Behind Lawn Mower Operator's Manual MODEL NUMBER YG1650 SERIAL NUMBER PURCHASE DATE Both model number and serial number may be found on the main labei.(SeePqe2,Fipre 1) You should record both of them in a safe place for future use. A WARNING READ AND UNDERSTAND THE ENTIRE MANUAL BEFORE OPERATING MACHINE. FAILURE TO COMPLY WITH THE SAFETY INSTRUCTIONS IN THE MANUAL MAY RESULT IN PERSONAL INJURY.
Your new YARDMAX® lawn mower offers quality construction and is easy and safe to operate. With proper use and care, it is designed to give you many years of dependable service.
Walk-Behind Lawn Mower Carefully read through this WARNING entire operator's manual before using your new unit. Pay attention to all cautions and warnings. A This walk-behind lawn mower is intended to be used by residential homeowners. it is designed primarily for cutting grass on well-maintained lawns on residential properties. It is not designed for cutting brush or for agricultural uses. It starts easy and cuts cleanly. The efficiency of the cutting system leaves your lawn looking spotless and clean.
SUPPORT Have questions about your YARD MAX equipment? Call us at 847-327-0566 or 844-YARDMAX, email us at support@yardmax.com, or contact us via your favorite social media site.
Walk-Behind Lawn Mower » Operator's Manual SPECIFICATIONS Model# Mower Type Cutting Options Cutting Width YG1650 Manual Push Bag, Mulch, Side Discharge 21" Max. Cutting Height 3.75" Min. Cutting Height 1.25" Cutting Height Options 7 positions Deck Material 16Gauge Deck Type Stamped Rear Bag Capacity Engine Power Type 2.01 cu ft. (57L) YARD MAX Gas Starting System Recoil Displacement 170cc Engine Torque 7ft.-lb Fuel Tank Capacity 0.21 gallon (0.8L) Oil Capacity 16.9 oz. (0.
SYMBOLS The rating plate on your machine may show symbols. These represent important information about the product or instructions on its use. ~ ~ ® e DANGER WARNING CAUTION Read these instructions carefully. ·~ ~ 'ill I~ Wear eye protection with side shields marked to comply with ANSI Z87.1. To reduce the risk of injury, keep hands and feet away from all pinch points, especially the cutting blades. Do not operate unless discharge cover or grass bagger is in its proper place.
Walk-Behind Lawn Mower » Operator's Manual SAFETY The definitions below give the level of severity for each signal word. .A DANGER This symbol points out important safety instructions. This machine was built to be operated according .A WARNING This symbol points out safety instructions. Read and follow all instructions before attempting to operate this to comply with these instructions to the safe operation practices in this manual. As machine.
Do not operate the machine while under the influence of drugs, alcohol, or any medication that could affect your ability to use it properly. the muffler is missing or defective. A defective muffler increases the noise level and the risk of fire. Examine the muffler regularly to make sure that it is attached correctly and not damaged. Wear sturdy, rough-soled work shoes and close-fitting slacks and shirts. Shirts and pants that cover the arms and legs and steeltoed shoes are recommended.
Walk-Behind Lawn Mower Store fuel in a cool, well-ventilated area, safely away from sparks, open flames, or other sources of ignition. Never store fuel or a machine with fuel in the tank inside a building where fumes may reach a spark, open flame, or any other source of ignition, such as a water heater, furnace, or clothes dryer. Allow the engine to cool before storing in any enclosure. » Operator's Manual • the product is incorrectly repaired.
If the equipment should start to vibrate abnormally, stop the engine and check immediately for the cause. Vibration is generally a warning of trouble. This manual cannot include all situations that can occur when you use the product. Be careful and use your common sense. Do not operate the product or do maintenance to the product if you are not sure about the situation. Contact Customer Support for assistance.
Walk-Behind Lawn Mower » Operator's Manual CONTENTS SUPPLIED Your YARDMAX lawn mower comes partially assembled and contains the following: r-------------, I I~ --""'/" _/ I ; ,~--!--------- ----!-::!~-~ '~_'\ '-q ,.. ~ 0----'--------------....-~-: .... ~ =---.--~--- I ~ _d - - - - - - - - ~,~1 1. Side Discharge Chute 8. Tools for Spark Plug Assembly 2. Lower Connecting Handlebar (1 pair) 9. Hardware Bag, Including 3. Grass Catcher M8x35 X2 4. Upper Handle 5. Main Machine X2 6.
ASSEMBLY This lawn mower was partially assembled at the factory. To assemble your machine follow the below instructions. LOWER CONNECTING HANDLEBARS UPPER HANDLE 1. Move the cutting height adjustment lever to the lowest position. Align the holes in the upper handle and the holes in connecting (See Figure 2, illustration 1) handlebars to set a comfortable height position for the handle, then 2.
Walk-Behind Lawn Mower » Operator's Manual CABLE POSITIONING 1. Hold the engine start/stop control lever against the upper handle. 2. Slowly pull starter rope handle from engine and slip starter rope into the rope guide. 3. Tighten rope guide knob. 4. Use cable tie to secure engine stop cable. (See Figure 4) FigureS GRASS CATCHER 1. Lift the mower's rear discharge door. 2. Slip the hooks in the grass catcher onto the rotating shaft of the rear discharge door.
KNOW YOUR MACHINE FEATURES AND CONTROLS Fuel Cap Side Discharge Chute Mulch Cover Front Wheel 13 I Know Your Machine
Walk-Behind Lawn Mower Engine Start/Stop Control )) A This engine start/stop control is a safety device. Never attempt to bypass its operation. Cutting Height Adjustment Lever )) Move this lever to desired position to change the cutting height. )) A The mulch cover is used for mulching purposes. Instead of collecting the grass clippings in a grass catcher or using the side discharge chute, some mower models have the option of recirculating the clippings back to the lawn. This is called mulching.
OPERATION ~ NOTE This unit is shipped without ADDING GASOLINE TO ENGINE gasoline or oil in the engine. Be certain to service engine with gasoline and oil as A instructed in the Engine Operator's Manual before WARNING Gasoline is highly flammable and explosive. You can be burned or seriously injured when handling fuel. Use starting or running your machine. extreme care when handling gasoline. ADDING OIL TO ENGINE A 1. Make sure the lawn mower is on a flat, level surface.
Walk-Behind Lawn Mower CUTTING HEIGHT ADJUSTMENT » Operator's Manual STARTING THE ENGINE The cutting height can be adjusted to 7 different positions. Raise wheels for low cut and lower wheels for high cut. Adjust cutting height to suit your requirements. Medium position is best for most lawns. Adjusting the cutting height may bring you into contact with the moving blade, causing serious injury. A WARNING To change cutting height, squeeze height adjustment lever in the direction of the wheel.
o For very heavy cutting, decrease the width of the cut by making an overlap of the cut path and cutting slowly. o Cut in different directions each time to prevent stripes in the lawn. o Regularly hose the grass catcher with water and let dry before use. Pores in cloth grass catchers can become filled with dirt and dust with operation. The grass catcher will then collect less grass. o The side discharging mode of your product is the best cutting mode.
Walk-Behind Lawn Mower » Operator's Manual EMPTYING THE GRASS CATCHER A CAUTION Do not drag the bag when you empty the grass catcher to prevent wear. 1. Lift the grass catcher with the frame handle. (See Figure 11) Figure 11 2. Remove grass clippings from the grass catcher from below the handle. 3. Empty grass clippings from the bag with the frame handle.
MAINTENANCE MAINTENANCE SCHEDULE Always stop engine, allow engine to cool, disconnect spark plug, and ground against engine before performing any type of maintenance on your machine. A In the maintenance schedule you can see which parts of your machine require maintenance, and at which intervals it should take place. The intervals are calculated based on average use of the machine, and may differ depending on the rate of your personal use.
Walk-Behind Lawn Mower 2. The transmission is pre-lubricated and sealed at the factory and » Operator's Manual CLEANING THE GRASS CATCHER does not require lubrication. 3. Follow the Engine Operator's Manual for lubrication schedule and instructions for engine lubrication. Pores in cloth grass catchers can become filled with dirt and dust during operation. This causes the grass catcher to collect less grass. To prevent this, regularly hose the grass catcher off with water and let dry before using.
4. Tip the machine onto its side (so that the air filter is up) to drain BLADE CARE the used oil from the oil-fill tube. (See Figure 14) Always stop the engine before you do work on the blade. The blade continues to rotate after the throttle has been released. Make sure that the blade is fully stopped and disconnect the spark plug cap before you start work. A WARNING The blade is sharp; contact with the blade can result in serious personal injury. Wear gloves when servicing the blade. A WARNING 1.
Walk-Behind Lawn Mower ~ NOTE You will need a torque wrench to install the blade properly. » Operator's Manual Use only a replacement blade approved by the manufacturer of your mower. Using a blade not approved by the manufacturer of your mower is hazardous, could damage your mower and void your warranty. A CAUTION A WARNING Position the curved ends of the blade to point toward the machine housing. 5. Install the new blade.
TRANSPORT AND STORAGE The following steps should be taken to prepare your lawn mower for storage. Keep all equipment safe during transportation to prevent damage and accidents. For storage, keep equipment in a lockable area away from children and persons that are not approved. Do not store next to corrosive materials, such as fertilizer. For storage, keep the product and equipment in a dry and frostproof area.
Walk-Behind Lawn Mower » Operator's Manual TROUBLESHOOTING Problem Engine fails to start Remedy Cause 1. Blade control disengaged. 1. Engage blade control. 2. Spark plug boot disconnected. 2. Connect wire to spark plug boot. 3. Fuel tank empty or stale fuel. 3. Fill tank with clean, fresh gasoline. 4. Engine not primed (If equipped with primer). 4. Prime engine as instructed in the Operation section of the Engine Manual. 5. Faulty spark plug. 5. Clean, adjust gap, or replace. 6.
38 ~ ~ ~ 0 V) ~ ~ 52 53 ~ c .J8 :r ~46 47 55/ .
Walk-Behind Lawn Mower » Operator's Manual YG1650 PARTS LIST Description No. Qty No.
yardmax.com Tame the Great Outdoors 847-327-0566 or 844-YARDMAX | ® info@yardmax.
