Instructions / Assembly

Danger Area
Support Rod
Gas Spring
Guide Bracket
M8 × 35 × 2
4
Figure 6a
Figure 7
Figure 6c
Figure 6b
Insert the extendable sides into mounting slots located on the
bottom panel. (See Figure 6b)
Fasten each at the bottom with two L pins and jam nuts. (See
Figure 6c)
Unlock the jam nut and loosen the L pins. No need to remove the
L pins. (See Figure 6a)
Lift up the hopper and insert a support rod for safety purpose.
Align the holes in the gas spring with the holes in both guide
brackets and insert M8x35 bolts, washers and nuts to tighten.
(See Figure 7)
FRONT PANEL & EXTENDABLE LEFT/RIGHT SIDE GAS SPRING
10 mm
13 mm
17 mm
19 mm
12 mm
9 mm
30 mm
8 mm
10 mm
13 mm
17 mm
19 mm
12 mm
9 mm
30 mm
8 mm
PLOW BLADE (OPTIONAL – SOLD SEPARATELY)
Figure 8a
1. Mount the mounting bracket to the blade using M8×30
hex bolts, washers and nuts. (See Figure 8a)
M8 × 30 × 4
1
M8×30 (×4)
Mounting Bracket
17 mm
18 mm
30 mm
24 mm
13 mm
11 mm
X 2
10 mm
13 mm
17 mm
19 mm
12 mm
9 mm
30 mm
8 mm
× 2
L Pins
Jam Nut
L Pins
Jam Nut
10
Mini Tracked Dumper
»
Operator’s Manual
YD8203PM01 - 1703
Assembly
|