Instructions / Assembly

TIRE PRESSURE

Check the pressure of tires periodically to make sure

they are properly inated. Recommended pressure is

30psi for all the tires.

Separation of tire and rim parts is possible when they

are serviced incorrectly.

Do not attempt to mount a tire without the proper

equipment and experience to perform the job.

Do not inate the tires above the recommended pressure.

Do not weld or heat a wheel and tire assembly.

Welding can structurally weaken or deform the

wheel. Heating can cause an increase in the air

pressure resulting in burst.

Do not stand in front or over the tire assembly while

inating.

ENGINE MAINTENANCE

Refer to the Engine Manual included in your unit

for the information on engine maintenance. Your

engine manual provides detailed information and a

maintenance schedule for performing the tasks.

Figure 10a

Figure 10b

Oil Filler

Oil Outlet

LUBRICATION

The gearbox is pre-lubricated and sealed at the

factory. No need to lubricate until 50 hours use.

After rst 50 hours use, change all the transmission

oil. Capacity is 1.5L.

For future use, just check the oil level every 50 hours

of working. If remove the drain plug, no oil ow out,

then add the oil.

Gear oil GL-5 or GL-6, SAE80W-90 is recommended.

Do not use synthetic oil.

Transmission oil must be replace when engine is

stopped and warm by unscrewing ller cap and drain

plug. When oil is completely drained, replace ller cap

and ll up with fresh oil. (See Figure 10a)

YD4103PM03 - 1807

Maintenance