Instructions / Assembly
Regular maintenance and lubrication will help keep your machine
in perfect working condition and ensure years of trouble free use.
Turn off engine and disengage all levers. Engine must be cool.
Inspect the general condition of the unit. Check for loose screws,
misalignment or binding of moving parts, cracked or broken parts,
and any other condition that may affect its safe operation.
Remove all debris and other materials that may have accumulated
to the brush. Clean after each use. Then use a premium quality
lightweight machine oil to lubricate all moving parts.
PREVENTIVE MAINTENANCE
ADJUSTING CLUTCH
MAINTENANCE
When the clutch begins to show wear, it will appear
thru the handle reach becoming wider. Making it more
difcult to reach. Follow these steps to return the
clutch lever back to its original position.
Never use a “pressure washer” to clean your unit.
Water can penetrate tight areas of the machine and
its transmission case and cause damage to spindles,
gears, bearings, or the engine. The use of pressure
washers will result in shortened life and reduce
serviceability.
Loosen the jam nut by turning it counter clockwise
with 10mm wrench. (see
Figure 7a, Illustration 1
)
Tighten or loosen the cable by turning the cable
adjustment nut clockwise or counter clockwise with
10mm wrench until you have reached your required
tightness. (see
Figure 7b, Illustration 1
)
Once tightness is set, return the jam nut against
the handle to hold the cable in place. (see
Figure 7b,
Illustration 2
)
1
1 2
Jam Nut
Adjustment Nut
Jam Nut
Jam Nut
Adjustment Nut
1
1 2
Jam Nut
Adjustment Nut
Jam Nut
Jam Nut
Adjustment Nut
3.
2.
1.
10
mm
13
mm
18
mm
19
mm
12
mm
7
mm
30
mm
8
mm
ADJUSTING STEERING
If steering becomes difcult to engage follow these
steps to adjust the cable tension.
Loosen the jam nut by turning it counter clockwise
with 10mm wrench while holding the lock nut in place
with 10mm wrench. (
See Figure 8a, Illustration 2
)
While holding the lock nut in place with a 10mm
wrench, tighten (or loosen) the cable by turning the
cable adjustment nut clockwise (or counter clockwise)
with a 10mm wrench until you have reached your
desired tightness. (
See Figure 8a, Illustration 3
)
Once you have reached your desired cable tightness,
tighten the jam nut by turning it clockwise until it is
tight against the lock nut. (
See Figure 8a, Illustration 4
)
3.
2.
1.
21
Jam Nut
Jam Nut
Lock Nut
Lock Nut
3
Adjustment Nut
4
Jam Nut
Adjustment Nut
Lock Nut
10
mm
13
mm
18
mm
19
mm
12
mm
7
mm
30
mm
8
mm
X 2
Figure 7b
Figure 7a
Figure 8a
17
YD4103PM03 - 1807
|
Maintenance