Operating Guide

Rubber Plug
Tank Cap
9
YC1160PM01 - 1703
|
Assembly
Wheel Axle Couple
M10 × 20 / M10 × 25 (×3)
Base Plate
Paving Pad
Clamp Plate
2. Before compacting, fold up the Wheel Kit. (See Figure 3b)
PAVING PAD KIT (OPTIONAL-SOLD SEPARATELY)
FUEL TANK CAP (YC1390 ONLY)
The Paving Pad is for use on decorative and delicate surfaces
like pavers, stone, and block. It prevents scuffs, scrapes, and
cracking of the stones while using the unit, and also will help
reduce operating noise.
Attach the Paving Pad onto the Base Plate as shown. Align
the holes in the Base Plate, Paving Pad and Clamp Plates, and
secure it with the bolts and washers found in Hardware Kit
Packet #3. (See Figure 5)
For YC1390, the last step is to remove the rubber cap used for
shipping from the gas tank. Then screw the tank cap (found in your
manual bag) into place. (See Figure 4a & Figure 4b)
Figure 3b
Figure 5
Figure 4b
Figure 4a
M10 × 20 × 3
YC1160
M10 × 25 × 3
YC1390
17 mm
18 mm
30 mm
13 mm
11 mm
29142US25M101.indd 9 2017/3/20 13:53:14