Full Product Manual

Plate Compactor

Operator’s Manual

Filter Seat

This plate compactor was partially assembled at the factory. To assemble your machine follow the below instructions.

ASSEMBLY

HANDLEAIR FILTER

1. Unfold the handle. (See Figure 3a)

1. Put the lter sponge element and lter core element into the

lter cover in order. (See Figure 2a)

2. Slide the two tongue of the lter cover into the slots of the

lter seat. (See Figure 2b)

3. Align the bottom hole in the lter cover and the hole in the

lter seat. Fasten them together with screw. (See Figure 2c)

2. Mount the handle as shown. Slide the handle ends into the

engine deck slots. (See Figure 3b). Secure with the at washers,

nuts and bolts found in packet #1 of the hardware kit.

3. Unwrap the throttle cable from around the top of the engine.

4. Unscrew bolt 5×35 from throttle control. Secure the throttle

control onto the upper handle with a at washer 5 and the bolt

5×35 that just were unscrewed. (See Figure 3c, illustration 1 & 2)

5. Fasten the throttle control cable with cable fasteners.

Figure 3a

Figure 2a

Figure 2b

Figure 2c Figure 3b

1 2

M5 (×1)

Lower Handle

M10 × 70 (×2)

Upper Handle

Assembly

Screw

Filter Cover

Filter Sponge Element

Filter Core Element

29140US25M100.indd 8 2017/3/20 13:50:23