Full Product Manual

Engine Mount Bolt (×2)
Engine Mount Bolt (×2)
REPLACING V-BELT(S)
1. Turn off engine. Engine must be cool.
2. Remove the belt guard to access the V-belt. (See Figure 7a)
3. Refer to the belt tension adjustment steps. If the engine can't
be moved to the back of plate any more, the belt may have to
be replaced.
4. Loosen the jam nut enough.
5. Push the engine toward the front of plate as far as possible, in
order to loosen the belts enough to slide them off.
6. Slip the old V-belt off the pulleys and install the new one in
their place.
When adjusting the belt, make sure that the clutch
pulley is in alignment with exciter pulley.
3. Tighten the engine mount bolts.
4. Attach the belt guard.
2. Push the engine by hand toward the back of plate to increase
belt tension, then tighten the jam nut. (See Figure 8c & Figure
8d)
Figure 8c
Figure 8d
Figure 8a
Figure 8b
V-Belt Clutch PulleyExciter Pulley
If the engine can't be moved to the back of plate any
more, the belt may have to be replaced.
LOOSEN TIGHTEN
Engine Connecting Plate
Jam Nut
15
|
Maintenance
17 mm
18 mm
30 mm
13 mm
11 mm
17 mm
18 mm
30 mm
13 mm
11 mm
29140US25M100.indd 15 2017/3/20 13:50:27