Replacement Part List

YB6770PM01 - 1609
PLASTIC SKID SHOES(OPTIONAL)
Optional reversible poly skid shoes protect decorative
surface.
CHUTE BRACKET
If the spiral at the bottom of the directional chute
control lever is not fully engaging with the chute
assembly, the chute bracket must be adjusted.
Loosen adjusting nuts on cable support bracket.
Slide the control cable up or down by threading
adjusting nuts to increase cable tension or provide
more slack.
Tighten nuts after proper adjustment is achieved..
To do so:
Loose the two nuts which secure the chute bracket
and reposition it slightly.
Retighten the nuts.
1.
1.
2.
2.
3.
10 mm
X 2
Figure 10
Figure 12b
Figure 12a
Figure 11
DRIFT CUTTERS (OPTIONAL)
Drift cutters break up snow drifts that are taller than
the auger housing and direct the snow into the auger.
Store the drift cutters on the auger housing when not
in use. Reposition drift cutters so they face forward as
shown. Wing nuts should be fastened on the outside
of the auger housing.
16
Two-Stage Snow Blower
»
Operator’s Manual
Adjustment
|