Replacement Part List

YB6770PM01 - 1609
HEADLIGHT WIRE CONNECTION
Lift up the shift rod. Insert the trunnion into the shift rod hole
on the bottom of the shift lever under the dashboard. Install
the washer and M8 nut. Tighten securely. (See
Figure 6c
)
To connect the headlight harness cut the zip tie holding the wire
off the engine, plug into the wire clip connected to the LED light,
use zip ties inside the manual bag to secure it to the handlebar to
avoid it being snagged during use. Cut excess strip off the zip ties
when secure. (See
Figure 7
)
3.

M8 X 1
8
Figure 6c
Figure 7
TIRES
The tires are over-inflated at factory for shipping purposes.
Check the pressure in the tires prior to usage. Reduce or increase
air pressure to ensure equal tire pressure to the manufacturer’s
recommended pressure. The recommended air pressure can be
found on the tire sidewall.
Trunnion
13 mm
2.

X 1
7
Figure 6b
,QVHUWWKHVKLIWURGZLWKDćDWZDVKHULQWRWKHVKLIWDUP6HFXUH
ZLWKWKHRWKHUćDWZDVKHUDQGFOHYLVSLQ6HH
Figure 6b
)
SPEED SHIFT LINKAGE
1.

6x25 X 1
6
Figure 6a
Place the shift arm on shift yoke. Make sure the linkage plate
points to the right. Line up the holes in the shift arm and shift
yoke. Insert a roll pin through the hole. (See
Figure 6a
)
11
|
Assembly
Under any circumstance do not exceed manufacturer’s
recommended pressure. Excessive pressure when
seating beads may cause tire/rim assembly to burst
with force sufficient to cause serious injury. Refer to
side wall of tire for recommended pressure.
Equal tire pressure should be maintained at all times. If
the tire pressure is not equal in both tires, the machine
may not travel in a straight path and the scraper blade
may wear unevenly.
Keep tires free of gasoline and oil, which can harm
rubber.