Replacement Part List

YB6770PM01 - 1609
Flange Keeper
2.
3.
Place the discharge chute facing it forward over the chute
FUDQNćDQJH6HH
Figure 4b
)
DIRECTIONAL CHUTE CONTROL
1.
4.
5.
2.
3.

M6 X 30 X 6
4

X 3
Figure 4c
Figure 4b
Figure 5a
Figure 5b

X 1
5

X 2

M8 X 1
13 mm
10 mm
10 mm
6HFXUHWKHWKUHHćDQJHNHHSHUVWRWKHERWWRPRIWKHFKXWH
crank flange by sliding the bolts through the chute base
holes, sliding the keepers up from the bottom, then securing
them with the included nuts. (See
Figure 4c
)
Slide the spiral end of the directional chute control lever into
the chute bracket.
Attach the directional chute control lever to the handlebar
through the upper hole on the left handle by sliding the bolt
thru the hole. Use the curved washer and nut to secure it to
WKHKDQGOHEDU/HDYHLWĆQJHUWLJKWIRUHDVLHUDOLJQPHQWODWHU
Secure the spiral end on the chute bracket by sliding on the
ćDWZDVKHUDQGFOHYLVSLQ6HH
Figure 5a
)
Make sure the spiral at the bottom is fully engaging with the
chute crank flange and tighten the two bolts on the chute
bracket. (See
Figure 5b
)
Tighten the nut which secures the directional chute control
on the handlebar.
10 mm
X 2
Chute Bracket
10
Two-Stage Snow Blower
»
Operator’s Manual
Assembly
|