Replacement Part List

YB6770PM01 - 1609
ASSEMBLY
HANDLEBARS SKID SHOES
2.
3.
1.
1.
4.
Keep the lower handle level and tighten two bolts from the
previous steps.
Raise the upper handlebars into operation position and slide
the three bolts and washers through the two holes on the
right side of the handlebar and the left lower hole. Secure
WKHPE\ĆQJHUWLJKWHQLQJWKHQXWV/HDYHWKHXSSHUKROHRQ
the left hand side without a bolt. This will be used to secure
the directional chute control assembly later. (See
Figure 2b
)
Ensure the handlebars are level and tighten all three nuts.
Loosen the two bolts on the sides of the transmission housing.
Slide the lower handle slots in-between the transmission and the
washer. Finger tighten the bolts to hold the handle in place.
Align the holes in the lower handle with the upper holes on both
sides of the transmission housing. Insert the bolts and curved
ZDVKHUVDQGĆQJHUWLJKWHQWRKROGLQSODFH6HH
Figure 2a
)
5.
2.
4.
6.
1.
3.
This snow blower was partially assembled at the factory. To assemble your machine follow the below instructions.
Figure 2a
Figure 2b

M10 X 40 X 2
1
M8 X 45 X 3
2
Place the machine is on a level and solid surface.
Lift the machine so that the scrapper blade is 1/8” (3mm)
above the ground, ensuring it is level. A piece of cardboard
half the thickness of the snow blower packaging placed
under the scrapper blade is recommended.
Attach the skid shoes to the sides of auger housing with the
bolts and nuts. The shorter M8X20 bolts should be in the front
holes while the longer M8X25 bolts in the rear holes. Move
the skid shoes down as far as possible. Be sure both skid shoes
are adjusted evenly. Tighten securely. (See
Figure 3
)
Sit the chute crank flange on top of the impeller housing.
Make sure the stop triangle points forward so that the
notched edge is on the left side and the pre-greased surface
is on the bottom. (See
Figure 4a
)
Remove the 1/8” (3mm) spacer you used from under the
scrapper blade.

M8 X 20 X 2
3

M8 X 25 X 2
Figure 3
Figure 4a
Lower Hole
Skid Shoe
Scraper Blade
1/8” (3mm)
1/8” (3mm) Cardboard
M8 X 25 Bolt
M8 X 20 Bolt
13 mm
DISCHARGE CHUTE
13 mm
16 mm
Chute Crank Flange
Stop Triangle
9
|
Assembly