Instructions / Assembly
OPERATION
Use the axle lock pin to lock or unlock the right or left wheel. Lock 
both wheels to increase traction; unlock one wheel to allow for 
easier turning of the unit; unlock both wheels for freewheeling.
To unlock wheel, slide it inward and insert the axle pin through the 
outer axle hole, but not through the wheel hub.
To lock wheel, slide it outward and insert the axle pin through the 
hole in the wheel hub and the outer axle hole.
Before starting the engine, check engine oil level and 
ensure the engine is served as described in the 
Engine 
Manual
 with the snow blower.
FREEWHEELING AND SELF-PROPELLING
Figure 17a
Figure 17b
STARTING AND STOPPING THE ENGINE
COLD START – RECOIL STARTER
WARM START
1. Be sure fuel shutoff valve is in the OPEN position.
2. Place ON / OFF switch in ON position.
3. Rotate choke control to CLOSED
position.
3XVKWKHSULPHURUWLPHV:KHQWHPSHUDWXUHLVEHORZr)
r&DGGLWLRQDOSULPLQJPD\EHQHHGHG:KHQWHPSHUDWXUH
LVDERYHr)r&SULPLQJLVQRWQHFHVVDU\
Follow the steps above, keeping the choke control in the OPEN
position and do not use primer.
5.     Grasp recoil starter handle and pull rope out slowly until it 
pulls harder. Let rope rewind slowly.
6.  Pull rope with a rapid continuous full arm stroke. Do not allow 
starter rope to snap back.
7. Repeat steps 5 and 6 until engine starts.
8.     When the engine starts, release the recoil starter handle and 
slowly move the choke control to the OPEN
position. 
2YHU SULPLQJ PD\ FDXVH ćRRGLQJ SUHYHQWLQJ WKH
HQJLQHIURPVWDUWLQJ,I\RXGRćRRGWKHHQJLQHZDLW
a few minutes before attempting to start and do not 
push the primer. 
Allow the engine to warm up for a few minutes, engine 
will not develop full power until it has reached normal 
operating temperature. 
In snowy and cold conditions, some controls and 
moving parts may freeze. Do not use excessive force 
when trying to operate frozen controls. If you have 
GLIĆFXOW\ RSHUDWLQJ DQ\ FRQWURO RU SDUW VWDUW WKH
engine and let is run for a few minutes.
17
|
 Operation










