Use and Care Manual

Engine Mount Plate
3. Remove the upper belt guard from the front housing and the
lower belt guard from the engine base by taking off the xing
bolts respectively. (See Figure 26)
4. Remove the four engine mounting bolts that secure the engine
to the engine base and slide the engine downward until the
engine pulley is disengaged from the belt. Remove engine from
engine plate and place on the side of unit. (See Figure 27)
Engine Base
Belt Tension Lever
Belt Cover
Belt
6. Place the engine back to the engine plate, reinstall four
mounting bolts, nuts and screws.
7. Place the upper and lower belt guard and reinstall and secure
the xing bolts.
5. Slip the old V-belts from the engine pulley and cutting disk
pulley then install the new V-belts. Align the engine pulley and
cutting disk pulley by moving the cutting disk pulley in or out
on the rotor shaft. Do not adjust by attempting to move the
engine pulley on the engine shaft. (See Figure 28)
16 mm
13 mm
18 mm
19 mm
30 mm
32 mm
16 mm
13 mm
18 mm
19 mm
30 mm
32 mm
X 2
Figure 25
Figure 26
Figure 27
Figure 28
When removing or installing the drive belt(s), be
careful to not get your ngers caught between the belt
and pulley.
LUBRICATION
Grease bearings every 40 hours of working. Being careful not to
overgrease. There are two bearings, one outside and one inside
of the housing.
Use portable tool lithium #0 grease such as Lubricant 6300AA,
Lubricant GR-132, or Multifak, e.g. EP-O.
ENGINE OIL / FUEL
Refer to the engine manual packed separately with your
unit for information on how to check or add oil/fuel and for
recommendations.
ENGINE MAINTENANCE
Refer to the engine manual packed separately with your unit for
detailed information and a maintenance schedule.
22
Chipper Shredder
»
Operator’s Manual
YW7565PM04 - 1710
Maintenance
|