Use and Care Manual

KNIFE REMOVAL AND REPLACEMENT
This chipper shredder is equipped with two chipper knives
mounted on the cutting disk. When the knives get dull or show
visible nicks, the machine will lose its self- feeding action and the
material has to be pushed in. Often it comes out in long strips.
Replace the knifes by following steps.
1. Remove the feed hopper. (See Figure 13)
2. Loosen the lock nut which holds the discharge chute on the
machine.
3. Remove the M8X25 bolts, at washers, and nuts that connect
the discharge chute and the housing.
4. Remove the discharge chute. (See Figure 14)
5. Rotate the cutting disc until the blade can be seen from the
feed hopper side. (See Figure 15)
6. Remove the bolts, nuts that x the blade. (See Figure 16)
Figure 13
Figure 14
Figure 15
Figure 16
M8x25
3
2 4
16 mm
13 mm
18 mm
19 mm
30 mm
32 mm
X 2
16 mm
13 mm
18 mm
19 mm
30 mm
32 mm
5 mm
16 mm
13 mm
18 mm
19 mm
30 mm
32 mm
X 2
18
Chipper Shredder
»
Operator’s Manual
YW7565PM04 - 1710
Maintenance
|