Use and Care Manual
OPERATION
FEED HOPPER
The feed hopper is where you insert your materials to
be chipped.
DISCHARGE CHUTE
Chipped materials are discharged through this
opening. The deector can be attached to the chute.
GRIP HANDLES
The handles are used to move the unit.
TRANSPORT WHEELS
To move the chipper shredder, grip the handles located
on the top of the opening of the hopper and tilt the
machine back until it is fully resting on the tires.
BELT TENSION LEVER
The belt tension lever is at the back of the housing.
Pull it up to engage the belt drive and run the cutting
disk. Push it down to disengage the belt drive and stop
the cutting disk.
DEFLECTOR LEVER
Loosen the deflector lever in a counter-clockwise
direction to adjust the discharge angle. Turn it
clockwise to tighten.
ENGINE ON/OFF SWITCH
The engine switch has two positions. OFF - engine will
not start or run. ON - engine will start and run.
RECOIL STARTER HANDLE
The handle is used to start the engine.
FUEL SHUT-OFF VALVE
The fuel shut – off has two position.
CLOSED
(
)
- use this position to service, transport, or store the
unit.
OPEN
(
) - use this position to run the unit.
CHOKE CONTROL
The choke control is used to choke the carburetor and
assist in starting the engine. The choke control slides
between the
CHOKE CLOSED
and
CHOKE OPEN
positions.
THROTTLE CONTROL
The throttle control regulates the speed of the engine
and will shut off the engine when it is moved to the
STOP
position. The throttle control moves between
FAST
,
SLOW
, and
STOP
positions.
ADD OIL TO ENGINE
1. Make sure the chipper shredder is on a at, level surface.
3. Using a funnel, add oil up to the FULL mark on the dipstick.
(See engine manual for oil capacity, oil recommendation, and
location of ll cap.)
The engine is shipped without oil. Do not start the
engine before adding oil.
Gasoline is highly ammable and explosive. You can
be burned or seriously injured when handling fuel.
Use extreme care when handling gasoline.
Fill the fuel tank outdoors, never indoors. Gasoline
vapors can ignite if they collect inside an enclosure.
Explosion can result.
DO NOT OVERFILL. Check engine oil level daily and
add as needed.
1. The engine must be off and allowed to cool at least two minutes
before adding fuel.
ADD GASOLINE TO ENGINE
2. Remove the oil ll cap/dipstick
to add oil.
CLOSEDOPEN
13
YW7565PM04 - 1710
|
Know Your Machine & Operation