Use and Care Manual

M8x25 (x2)
M8x25 (x2)
Feed Hopper
4. Remove the M8X25 bolts, at washers, and nuts from the
machine where the feed hopper will be attached. Set aside for
later use. (See Figure 6)
5. Place the feed hopper onto the machine. Make sure the lip on
the hopper goes over the chute housing on the main machine.
Tighten the feed hopper on the unit with M8x25 bolts, washers
and nuts. (See Figure 7)
Figure 6
Figure 8
Figure 9
Figure 7
FUEL CAP
UNLOCKING
Remove the rubber plug and screw the fuel cap. (See Figure 8)
Remove the bolt securing the mounting stand to the pallet. Cut
the strap securing the front mounting stand to the pallet. Check
over all nuts and bolts on the machine to ensure they are tight.
(See Figure 9)
Remove the machine away from the pallet.
16 mm
13 mm
18 mm
19 mm
30 mm
32 mm
X 2
16 mm
13 mm
18 mm
19 mm
30 mm
32 mm
X 2
Mounting Stand
16 mm
13 mm
18 mm
19 mm
30 mm
32 mm
X 2
1 2
Fuel CapRubber Plug
11
YW7565PM04 - 1710
|
Assembly