Installation Guide

35
Align the opposite end with the center of the

through pre-drilled holes.
Align the Angle Cut Roof Band Board with the
Straight Cut Roof Band Board and fasten with two

Continue working all the way around to install the
remaining Roof Band Boards, as shown in previous
steps. You may need to adjust the top of the Double
Rafters, to align the Band Board with the center of
the Double Rafters.
Roof Assembly
Step:167
Step:169
Step:168
Continue to tighten all the Roof Bolts at the Ridge
and all the Post locations.
Continue installing all remaining Band Boards.
Using a 
tighten all Roof Bolts that were previously
installed.
Step:170
Step:171
Step:172
Align Here
Screw
Locations
Align Here
Screw
Location