Installation Guide

29
Install the rest of the 2 
pre-drilled hole location. Repeat Steps 132-135 on
the second Roof Panel.
Place one Rafter ply on each side of the Roof Panel
Assembly. Notice the angle cut direction on the
Rafter plies.
Locate the Angle Cut Roof Band Board. Hold in
place as shown.
While holding the Rafter Ply in place, you may
remove the Angle Cut Band Board and fasten the
Rafter Ply to the Roof Assembly with 2 
through pre-drilled holes.
Roof Assembly
Take two Double Rafters apart to make four Pieces.
Step:131
Step:133
Step:132
Step:134
Step:135
Locate the Compression Ring. Remove the eight
(8) Screws from the top of Compression Ring.
Step:136
Angle
Cut Band
Board
Align
Here