Installation Guide

42
Fasten the opposite end, as shown in Step 210.
Install the Tar Paper on all the Angled Section, as
shown in Steps 206-208.
Locate the Straight Cut Tar Paper. Overlap onto the
Angled Roof Sections and fasten approximately

Tar Paper
Locate the Pre-Cut Tar Paper. Place the Large piece
at the bottom as shown.
Center the Tar Paper onto the Roof Section. Fasten
Tar Paper to T&G Boards using a Hammer Tacker.
Step:206 Step:207
Step:209Step:208
Step:210
Step:211
Place the Small Tar Paper piece on the top side.
Overlap the Small piece over the Large piece by

Align
at the
bottom
Overlap