Installation Guide

28
You will need to Lift the Ridge Piece and the
Rafter to assemble this side. Align the bevel cut on the
Ridge Piece with the top of the Rafter. Align the notch

Screws through pre-drilled holes.

Assemble the second Roof Panel, as shown in
Steps 199-128. (You will need two Roof Panels
like the one shown above.)
Roof Assembly

ways with the Rafter With Pre-Drilled Hole. Fasten

Rafter With Pre-Drilled Hole at the opposite end.
Center the Rafter Without Pre-Drilled Hole, with
the holes drilled in the Band Board. Fasten using

Step:125 Step:126
Step:128
Step:127
Step:129
Align
Here
Screws
Locate the Double Rafters. Reverse all the Screws
to separate the two plies.
Step:130