Installation Guide

27
Place another Rafter With Pre-Drilled Hole on the
opposite side. Then Place the Rafter Without
Pre-Drilled Hole in the center.
Locate the Straight Cut Roof Band Board. Locate the Rafter With Pre-Drilled Hole.
Place the Rafter With Pre-Drilled Hole in between
the other two Boards. Ensure the Pre-Drilled Hole
is towards the Straight Cut Roof Band Board.
Roof Assembly
Locate the Ridge Piece. Place on a clean, level surface with the notches
facing up.
Step:119 Step:120
Step:122
Step:121
Step:124
Step:123
Pre-Drilled Hole
Pre-drilled hole