Installation Guide
16
Fasten through pre-drilled holes with two (2) 2
Screws.
Locate the second round of the Angled Deck
Boards.
Place the Angled Deck Boards all the way around.
Ensure Deck Boards are tight together. There
round of Deck Boards. Ensure there is an equal gap
all the way around.
Pre-drill one (1)
into the Band Board below. Then fasten using 2
Screw.
Using the pattern shown above, pre-drill a
through Deck Boards at the Single Joist Locations.
Then fasten using 2
Step:61 Step:62
Step:64Step:63
Step:65
Step:66
Floor Assembly
Equal Distance