Installation Guide
9
Place the Double Floor Joists, as shown.
Fasten all remaining screws at these locations. Repeat Steps 19-21, to install the remaining three
Joists.
Locate the remaining Double Floor Joists.
Floor Assembly
Locate the Angle Cut Floor Band Board. Hold in
place as shown.
Push the Angled Band Board tight against the
Straight Band Board. While holding this in place,
Fasten the Floor Joist Ply to the Single Floor Joist
with 2
Step:19 Step:20
Step:22
Step:21
Step:24
Step:23
Angle Floor
Band Board