Installation Guide

Tar Paper

Step:194 Step:195

Step:197

Step:196

Step:198

Locate the Large Pre-Cut Tar Paper. Start by

placing the Large piece at the bottom. Slide under

the Straight Cut Tar Paper.

Fasten Tar Paper to Tongue & Groove Boards



Place the Small Pre-cut Tar Paper on top of the

large Tar Paper and overlap the Tar Paper by 2

inches. Be sure to slide under the Straight Cut Tar

Paper. Fasten Tar Paper using a Hammer Tacker



Install all remaining Tar Paper on the Roof

Panels, as shown in Steps 194-197.

Locate the Ridge Tar Paper. Center the Ridge Tar Paper and fasten using a



Step:199

Align

Here

Slide under Previously

installed tar paper