Installation Guide

27
Install the rest of the 2 
pre-drilled hole location. Repeat Steps 123-126 on
the second Roof Panel.
Place one Rafter ply on each side of the Roof Panel
Assembly. Notice the angle cut direction on the
Rafter plies.
Locate the Angle Cut Roof Band Board. Hold in
place as shown.
While holding the Rafter Ply in place, you may
remove the Angle Cut Band Board and fasten the
Rafter Ply to the Roof Assembly with 2 
as shown.
Roof Assembly
Screws reversed. Take two Double Rafters apart to
make four Pieces.
Step:122
Step:124
Step:123
Step:125
Step:126
Locate the Compression Ring. Remove the eight
(8) Screws from the top of Compression Ring.
Step:127
Angle
Cut Band
Board
Align
Here