Installation Guide

26
You will need to Lift the Ridge Piece and the
Rafter to assemble this side. Align the bevel cut on the
Ridge Piece with the top of the Rafter. And align the
notch with the side of the Rafter. Then fasten with two


Roof Assembly

ways with the Rafter With Pre-Drilled Hole. Fasten

other Rafter With Pre-Drilled Hole.
Center the Rafter Without Pre-Drilled Hole, with
the holes drilled in the Band Board. Fasten using

Step:116 Step:117
Step:119
Step:118
Step:120
Align
Here
Screws
Assemble the second Roof Panel, as shown in
Steps 110-119. You will need two Roof Panels like
the one shown above.
Locate the Double Rafters. Reverse all the Screws
to separate the two plies.
Step:121