Installation Guide
16
Fasten through pre-drilled holes with 2
Screws through pre-drilled holes. Two (2) Screws
at each end of each Deck Board.
Locate the remaining Angled Deck Boards and
place them all the way around.
Ensure Deck Boards are tight together at the angle
and second round of Deck Boards. Ensure there is
an equal gap all the way around.
Pre-drill one (1)
into the Band Board below at the Red arrow
location. Then fasten using 2
Using the pattern shown above, pre-drill a
through Deck Boards at the Single Joist Locations.
Then fasten using 2
Step:61 Step:62
Step:64Step:63
Step:65
Continue fastening through pre-drilled holes all the
way around.
Step:67
Floor Assembly
Equal Distance
Deck Screw
Location