Owner Manual

9
(44) Make a mark 4-5/8” down
from top of siding. Repeat on op-
posite end.
(46) Align bottom of 1x3 soffit
strip with chalk line, and keep
flush with wall frame, then secure,
using 2” nails, and nailing on
every stud.
(45) Snap a line, using the marks
from the previous step.
(50) Set the wall, making sure
edges of wall are flush with edges
of floor. Note: It is VERY impor-
tant that a person holds the wall
in place until wall is attached
firmly to floor, or braced.
(51) INCORRECT! Wall needs to
be flush, and in against the floor
frame, and down against the floor-
ing.
(52) CORRECT! Move to next
step.
(47) Repeat for the rest of the
soffit strips, making sure the bot-
tom of soffit strip is even with the
line.
(48) Install soffit, starting on the
right side of the wall, with the
overlap edge sticking out 1/2” past
the wall frame.
(49) Fasten the rest of the soffit
much the same way as the siding.
Last soffit piece should overhang
by 1/2”as well. If necessary, cut to
fit.
[phone] - [e-mail]
Install Soffit
Set Back Wall