Owner Manual

8
(35) Nail along the top, after mak-
ing sure the siding is flush with the
center of the double top plate as
shown. Use an 8” to 12” nail spac-
ing.
(37) Ensure that stud is parallel
with siding, before nailing. Then
firmly attach siding section along
all edges and into each wall stud,
using an 8” to 12” nail spacing.
(36) Nail along the end, making
sure siding is 1/2” out over the
wall stud.
(41) Repeat previous steps for the
rest of the siding.
(42) Snap a line, even with the edge
of the wall frame, then move to
next step.
(43) Set the saw to 1/2” and cut
along the line so that it is flush
with wall frame.
IMPORTANT! Do not cut along
the bottom of wall.
(38) Put the next piece in place,
flush with the previous piece, mak-
ing sure the splice looks similar to
the other grooves. Then fasten the
corner of the siding to the plate.
(39) Nail along the top as done in
previous piece.
(40) Nail along the splice, making
sure the splice is parallel, and
looks similar to the other grooves.
[phone] - [e-mail]