Owner Manual

4
(1) Place the package as close to
the assembly location as possible.
(3) Remove and organize parts
from package.
(2) Cut package bands.
Note: Floor unit is packaged sepa-
rately.
Unpack The Kit
Assemble Floor
(7) Begin with the end joist, making
sure the band board is flush with
the joist.
(8) Attach the band board, using 3”
screws, through the pre-drilled
holes.
(9) Screw the rest of the band-
boards into floor joists.
Important! Band board splice
needs to be tight.
(4) After making sure the pad is
level, locate the parts to assemble
the floor joists, and scatter them
out as shown.
(5) Note: The band boards have
dado grooves precut to ensure
proper joist placement.
The narrow grooves should
both be placed at the splice.
(6) The wider grooves should be
placed at the ends.
[phone] - [e-mail]