Owner Manual

21
(152) Fasten the other hinges,
keeping door flush with the trim
on the left side.
(154) Finish fastening the rest of
the hinges, using previous steps.
(153) Repeat for the right door,
again, making sure you keep the
top of the door down from the
trim, approximately 1/4” as shown.
(158) Install latch using 2” black
screws.
(159) Attach L-handle as shown
using a 5/32 Allan Wrench. Adjust
as needed.
(160) Make a mark at 12”, then
install door spring, as shown in
next step.
(155) Pull door in, tight against
the frame, then make a mark for
the inside latch pin. Repeat on the
bottom.
(156) Drill a hole, with 5/16” drill
bit, using the pre-made marks.
(157) Repeat on the bottom.
[phone] - [e-mail]