Owner Manual

18
(125) Repeat previous steps for the
back side.
Note: If the marks on the
sheathing do not align properly
with the rafters, you will need to
lift a corner of the building, to
adjust it.
(127) Make a mark flush with the
gable fascia, then cut to length.
(126) Hold the fascia in place,
making sure it is centered with the
rafter, then move to next step be-
fore nailing.
(131) Make a mark, flush with the
fascia on the bottom as shown,
then refer to next step.
(132) Cut along the mark as shown. (133) Completed! Repeat on the
other three corners.
Note: This is the best time to
paint the shed; before the win-
dows, shingles, doors, corner
trim, and vents are on.
(128) Fasten to rafters, using two
2” trim nails per rafter, and making
sure fascia is flush with the top of
the rafters, and with the gable fas-
cia.
(129) Repeat previous steps, mak-
ing sure this piece is tight against
the other piece as shown, before
cutting to length and fastening.
(130) Repeat previous steps for the
fascia on the back side.
[phone] - [e-mail]
Install Front And Back Fascia