Owner Manual

17
(116) Locate the roof sheathing,
and scatter out as shown.
(118) Starting with the left piece,
push roof sheathing tight against
the gable overhang, and align flush
with bottom edge of gable rafter,
then attach, using a 2” nail.
(117) Starting from the end, make
a mark every 24”.
(122) Pull gable overhang parallel
with the roof sheathing, then attach
along gable rafter, using 2” nails
every 8 to 12 inches.
(123) Adjust the rafters to align
with the marks you had made in
step (126), then fasten the top of the
roof sheathing to rafters. Finally,
nail the rest of the roofing, using an
8 to 12 inch nail spacing.
(124) Lay out the top row sheath-
ing, making sure the splices are
alternated, as shown in step (116)
Fasten the last row securely, using
the previous steps.
(119) Make sure sheathing is cen-
tered on rafter, then attach at bot-
tom right corner. Important! Nail
along the bottom at every rafter,
before moving to next step.
(120) Fasten the bottom left corner
of the next piece of roof sheathing,
making sure the edges are aligned
perfectly.
(121) Fasten the sheathing on the
bottom right corner, making sure it
is flush with bottom edge of gable
rafter. Important! Nail along
the bottom, at every rafter be-
fore moving to next step!
[phone] - [e-mail]
Install Roof Sheathing