Owner Manual

14
(89) Repeat with other window
openings. *If applicable*
(91) Align the rafters as shown,
then move to next step.
(90) Lay out the rafter pieces and
the gussets. Note: Two rafters will
be assembled using only one rafter
gusset, the remaining rafters will
be assembled using two rafter gus-
sets.
(95) Screw rafter to top plate, us-
ing a 3” screw, making sure rafter is
flush with the wall siding. Repeat
for opposite end of rafter.
(96) Repeat these steps for the
other gable rafter.
(97) Install the rest of the rafters,
24” on center, or in every dado
groove on the top plate. Repeat, till
all rafters are installed.
(92) Assemble each rafter by at-
taching one gusset to each side of
the rafters as shown, using a total
of ten 2” nails per gusset.
(93) Begin with end rafter keeping
single gusset facing to interior of
shed as shown.
Important: One person needs to
hold the rafter while another
person fastens it.
(94) Align rafter flush with edge of
soffit, then screw soffit to rafter,
using 3” screws. Repeat for oppo-
site end of rafter.
[phone] - [e-mail]
Assemble Rafters
Install Rafters