Owner Manual

13
(80) Locate and lay out the gable
siding with overlap towards the
front.
(82) Nail siding along top edge,
making sure the siding is parallel
with the center of the double top
plate.
(81) Align siding flush with the
top, and edge of front wall siding,
using 2” siding nails.
(86) Run a 2” screw through sid-
ing at each corner of the window.
(87) Use the screws to snap a chalk
line outlining window frame.
(88) Remove the screws and
chalk line, then; set the saw at
1/2”, and cut along the lines.
(83) Incorrect! Ensure bottom
corner of siding is properly
aligned.
(84) Correct! Attach to wall
studs, using 2” siding nails.
(85) Install remaining siding
pieces, then repeat the process for
the opposite gable, again; making
sure overlap is towards the front.
[phone] - [e-mail]
Cut Out For Windows