Use and Care Manual

[phone] - [e-mail]
9
(41) Attach all wall studs to top
and bottom wall plate.
(43) Done! (42) Before fastening the double
top wall plate, ensure that dado
grooves align with wall studs, and
are faced outward.
(47) Nail along the top, after mak-
ing sure the siding is flush with the
center of the double top plate as
shown. Use an 8” to 12” nail spac-
ing.
(48) Nail along the end, making
sure siding is flush with the wall
stud.
(49) Ensure that stud is parallel
with siding, before nailing. Then
firmly attach siding section along
all edges and into each wall stud,
using an 8” to 12” nail spacing.
(44) Lay out siding as shown here,
with the overlap towards the left.
(Refer to drawings)
(45) Starting with the left piece,
place the siding even with the cen-
ter of the double top plate, and
flush with the wall stud.
(46) Nail this corner with one 2”
nail, before moving to the next
step.
Install Back Wall Siding