Use and Care Manual

4
[phone] - [e-mail]
(1) Place the package as close to
the assembly location as possible.
(3) Remove and organize parts
from package.
(2) Cut package bands.
Note: Floor unit is packaged sepa-
rately.
Unpack The Kit
(4) Locate and lay out the 6’ pres-
sure treated 2x4 Sill Plates, cutting
them to length as needed.
NOTE: Perimeter needs to be
square, and exactly 10’x18’
(5) Fasten the sill sealer (Not pro-
vided) to the bottom of the sill
plate. (You will need approxi-
mately 60 feet)
(6) After making sure the sill
plates are in the proper position,
pre-drill holes, then fasten to the
foundation, using 3” Tapcon
screws, (Not provided)
(7) After all the walls are set, per-
manently anchor the walls, first;
pre-drilling the holes, using a 1/2”
concrete bit, (Not provided) then,
move to next step.
(8) Fasten the walls to the founda-
tion, using 1/2” x 7” galvanized
wedge anchors, (Not provided)
and space them every 4 to 6 feet,
or according to local code require-
ments.