Use and Care Manual

[phone] - [e-mail]
23
(167) Fasten the other hinges,
keeping door flush with the trim
on the left side.
(169) Finish fastening the rest of
the hinges, using previous steps.
(168) Repeat for the right door,
again; making sure you keep the
top of the door down from the
trim, approximately 1/4”.
(173) Install latch using 2” black
screws.
(174) Attach D-handle as shown
using a 5/32 Allan Wrench. Adjust
as needed.
(175) Make a mark at 12”, then
install door spring, as shown in
next step.
(170) Pull the left door in, tight
against the frame, then make a
mark for the inside latch pin. Re-
peat on the bottom.
(171) Drill a hole, with 5/16” drill
bit, using the pre-made marks.
(172) Repeat on the bottom.