Use and Care Manual

[phone] - [e-mail]
19
(131) Locate the roof sheathing,
and scatter it out, starting with a
full 4’x8’ piece on the right side.
(133) Starting with the right piece,
push roof sheathing tight against
the gable overhang, and align flush
with bottom edge of gable rafter,
then attach, using a 2” nail.
(132) Starting from the end, make
a mark every 24”.
(137) Pull gable overhang parallel
with the roof sheathing, then attach
along gable rafter, using 2” nails
every 8 to 12 inches.
(138) Adjust the rafters to align
with the marks you had made in
step (132), then fasten the top of the
roof sheathing to rafters. Finally,
nail the rest of the roofing, using an
8 to 12 inch nail spacing.
(139) Lay out and fasten the top
row sheathing, making sure the
splices are alternated.
(134) Make sure sheathing is cen-
tered on rafter, then attach at bot-
tom left corner. Important! Nail
along the bottom at every rafter,
before moving to next step.
(135) Fasten the bottom right cor-
ner of the next piece of roof
sheathing, making sure the edges
are aligned perfectly. Then repeat
previous steps for the next pieces.
(136) Important! Nail along the
bottom, at every rafter before
moving to next step!
Install Roof Sheathing