Use and Care Manual

10
[phone] - [e-mail]
(50) Put the next piece in place,
flush with the previous piece.
(52) Nail along the top, after mak-
ing sure the siding is flush with the
center of the double top plate.
(51) Make sure the splice looks
similar to the other grooves. Then
fasten the corner of the siding to
the plate.
(56) Set the saw to 1/2” and cut
along the line so that it is flush with
wall frame, as shown in next step.
(57) Example!
(58) Done!
(53) Nail along the splice, making
sure the splice is parallel, and
looks similar to the other grooves.
(54) Repeat previous steps for the
rest of the siding.
(55) Snap a line, even with the
edge of the wall frame, then move
to next step.