Installation Guide

Fire Table Burner Install Manual
If no leaks are present, your system is ready to use.
Operating procedure
AFTER IGNITION, CONTINUE TO DEPRESS
KNOB FOR 3-5 SECONDS, THEN ROTATE
TO DESIRED FLAME HEIGHT
1
3
2
5
6
Fasten fire table top to the base using a
separately provided instruction manual.
Remove the four screws and control knob attached to the brass
valve fitting. Then remove the ignition button and plastic
washer from the sparker box.
4
Carefully place the burner tray into the top
tray.
Connect the hose and regulator to the
self-contained propane cylinder
Secure the sparker box and valve fitting to the control panel
by using the plastic washer and screws that were previous-
ly removed. Then insert a AAA battery into the sparker box
and attached the ignition button.
ROTATE COUNTER-CLOCKWISE
TO LOW AND SLOWLY DEPRESS
PRESS AND HOLD SPARKER
BUTTON
YARDBIRD
Please place item on a soft/ non-abrasive surface for assembly
to avoid damaging your new piece
P
U
S
H