Product Manual

9
With the help of another person, make sure to
position the discharge chute over the top neck of
the chipper correctly. Each position holding pin
must enter a hole on the top neck ring. Once this is
ready, you need to brace the chute with the
brackets below. Shown pic below.
You must tighten the brackets with the safety hex
nuts equally around the neck. You need to tighten
just enough to allow the neck to rotate while
reaching minimum play.
Tip: Grease the upper surface of the chipper neck
and the bottom ring of the discharge chute so the
discharge can rotate easier. These parts are
powder coated, they have good slipping between
surfaces, but they can get stuck under pressure.
Step 9 Connecting the battery
The only cable you need to connect to the battery
is the (+) positive one. It is generally a thick cable
(1/0 AWG) that runs from the positive terminal of the
battery to the starter motor of your engine. This
cable ships already in place and connected.
To connect simply unscrew the bolt on the positive
end of the battery and place the connect as
shown on the picture below.
Slide the bolt and screw again. This connection
need to be made tight enough to ensure good
current transfer.
Step 9 Filling the engine with Oil.
In this section we give you general instructions for
for preparing your engine for starting. However it is
your responsibility to read the engine manual and
follow the instructions for preparing, starting,
operating and maintaining your engine.
Choosing the right oil in your engine depends much
on the type of climate you will be operating. For
better reference below is a detail of the oil type
required for the working temperature range that
the engine will endure.
Therefore, we recommend using synthetic 10W-30
oil as it will be the most versatile in different types of
climate.
 Please refer to your engine manual for the
amount of oil required to fill up the engine.
(if chipper is fitted with a CH640 Kohler, this
engine tipically utilizes approx. 1.9 U.S quarts
on refills. When engine is new, you may
need to add more as the oil fills up the
crankcase.