Product Manual

Step 3 Wheel assembly

With the help of scissor jack, place the jack

underneath the trailer close to one of the wheel

hubs. Raise the trailer high enough fo the wheel to

fit. If needed, you may increase lifting height by

adding a small wood block below the jack first.

Below is a guiding illustration. Chock the assembled

wheel when inserting the other wheel.

Do not attempt to lift the unit by yourself or

someone else, please bear in mind most of the

chipper weight, more than 700lbs, is placed over

the wheel shafts.

Once height has been reached insert wheel into

the wheel hub. Attach the wheel with the wheel

lugs. Do not tighten with drive until the unit has both

wheels fitted and the trailer is resting on the floor.

Wheel nuts must be tightened in stages. Begin

tightening by hand to prevent cross threading. Then

torque each lug nut to 20-25 ft-lbs, and then torque

to 50-60 lbs-ft. Lastly torque the lug nuts to 90-120ft-

lbs.

Tigthening

Sequence:

Step 4 Tongue assembly

Remove first the front step block that secures the

front of the chipper with a hammer (use the nail

remover side).

With the help of a another person attempt to lift the

front of the chipper high enough to place some

wood blocks underneath. Attempt to position the

jack and lift. Make sure the jack is not blocking the

area where the tongue will be assembled. See pic

below.