Product Manual

With the help of another person, position the
tongue and insert fasteners (from the top down).
Insert flat washer and then safety hex nut. Tighten.
Step 5 Trailer Jack assembly
With the help of another person, position the
tongue and insert fasteners (from the top down).
Insert flat washer and the safety hex nut. Tighten.
Step 6 Feed Hopper Assembly
Hopper is already pre-assembled.
With the help of another person, position the feed
hopper into its transition-feed chute. Tighten.
Step 7 Discharge Chute Assembly
Please slide flange ring over the top neck of the
chipper. See pic above
With the help of another person, make sure to
position the discharge chute over the top neck of
the chipper correctly. Each position holding pin
must enter a hole on the top neck ring. Once this is
ready, you need to brace the chute with the
brackets below. Shown pic below.