Product Manual

Maintenance and Storage
1.Never tamper with the safety components. Check
periodically that they are functioning properly.
2 . Make sure all screws, bolts , pins and cotter
pins are in good condition to make sure the
machine is in safe operating condition . Also ,
visually inspect the chipper to check for damages
and determine if repair is necessary.
3. Lubricate bearings as often as maintenance
chart indicates(found below) to avoid wear ; it also
protects from corrosion and reduces heat stress
thus extending their operating life.
4. Before cleaning, repairing or inspecting
the chipper, stop the engine and check that all
moving parts have stopped.
5 . Do not change the engine governor settings or
overspeed the same. The governor controls the
maximum safe operating speed of the engine.
6. Maintain or replace safety and instruction labels
as necessary.
7. Follow the instructions in this manual for safely
storing this machine during off season.
8. Never store the chipper or fuel container
in an enclosed space where there is presence of
flame, spark or pilot light such as water heaters,
furnaces, clothes dryers, etc.
9. Allow machine to cool at least 10 minutes before
storing after shutting it down.
10. Always refer to the engine manual for proper
instructions for off-season engine storage.
11. If you need to empty the fuel tank, do it
outdoors and away from possible spark sources.
12. Observe the local rules for proper disposal laws
for oil, fuel and greased towels.
ASSEMBLY OF THE UNIT
Tools needed for the assembly of this unit:
1- Rubber mallet
1- Hammer with nail remover
2- 7/16” hex wrench
2- ½” hex wrench
2- 9/16” hex wrench
1- 11/16” hex socket
1- 3/8” hex socket
1- pliers
1- ratchet drive
1- ratchet extension
1- small scissor jack & small wood blocks
Step 1 Lifting cage out
With the 3/8” hex socket loosen the 4 screws
attaching the cage to the pallet. You can also do
this with a 3/8” hex wrench.
Make sure you have another person to help you lift
the cage up as it is too big for one person only.
Step 2 Take apart components from the pallet.
Please take out of the packaging all components
strapped with stretch wrap such as wheels, trailer
tongue, feed hopper, etc. Make sure to remove
step blocks that hold the axle in place with a
hammer (use the nail remover side).