Product Manual

9
-Insert rotating axle and bolt it as shown in
Figure below.
a. 4 Hex Bolts 3/8 "x 1"
b. 4 Hex Nuts 3/8 "
c. 4 Pressure Washers 3/8 "
d. Plain Washers 4 3/8 "
1. Insert tires in their shafts.
-Place a safety cotter pin across each shaft
with pliers and bend the ends to prevent
any loose tires when operating or towing, as
shown in Fig.
4- 5/8” Washers
4 Cotter Pins 3/16 "x 1"
 Pull Bar Assembly
-Next figure shows the assembly of the pull
bar.
- Place 2 flat washer across each tongue. (4
washers in total), slide pin and make sure to
slide pull bar as well.
-Secure in place using safety cotter pins and
bend the ends to prevent slipping of the pin.
Nuts and Bolts: 1/8 "x 1" cotter pins (2 units)
4 Special Washers (custom made)
 Feed Hopper Assembly
-Assemble the hopper as shown in Fig.
Nuts and bolts:
a. 9-Hex Bolts 5/16"x 1"
b. 9-Pressure Washers 5/16 "
c. 9-Plain Washers 5/16 "
d. 9-Hex nuts 5/16 "