Product Manual

6
5. Perform a visual inspection of the
machine in frequent intervals to check
whether the chippers has suffered any
important damage.
6. Maintain and replace the safety labels
and instructions as necessary.
Safe Handling of Fuel
To avoid personal injury or property
damage, be very careful when handling
fuel. The fuel that is used, -gasoline- is highly
flammable and the vapors are explosive.
You can be seriously injured if fuel is spilled
on yourself or your clothes which can ignite.
Wash your skin and change clothes
immediately.
1. Use only containers approved for
Gasoline.
2. Never fill containers inside a vehicle or
truck. Always place containers on the
ground away from your vehicle before
filling.
3 . Keep the nozzle in contact with the
edge of the entrance to the engine fuel
tank or container at all times until it is full
at recommended engine manufacturer
specifications.
4 . No smoking should take place. Turn
off all cigarettes, cigars, pipes and other
sources of ignition.
5. Never refuel the engine indoors.
6. Never remove gas cap or add fuel
while the engine is hot or running . Allow
engine to cool at least two minutes
before re- fueling .
7. Never overfill the fuel tank . Fill tank to
no more than 1/ 2 inch below the base
of the neck of the thread to allow room
for fuel expansion.
8. Place the fuel cap back on and
tighten securely .
9 . Clean up spilled fuel on the engine
and equipment. Move machine to
another area. Wait 5 minutes before
starting the engine.
Operation of the Wood Chipper
1.Check the oil and fuel level before starting
the engine.
2 . Do not put hands near rotating parts or
power inputs . Contact with the chipper and
rotating parts –while in operation- can
serioulsy damage fingers, hands .
3. Before operating the chipper , open it.
Check and clean the rotor of foreign debris
objects , make sure the cutting chamber is
empty and free of any foreign material.
4 . Thoroughly inspect all material to to be
chipped and remove any foreign objects -
such as nails, glass, steel wire, etc- that
could cause injury to you or damage the
machine.
5 . Do not attempt to chop material larger
than specified in this manual. This action
puts yourself and the machine at risk.
6. Keep all guards and safety elements in
place and in good condition.
7. Do not operate this machine while under
the influence of alcohol or drugs.
8. Never operate this machine without good
visibility or light .
9. If the engine is hot, do not touch as it may
cause severe burns.
10. Do not attempt to move the chipper
while the engine is running .
11. While feeding material into the machine,
keep your face and body away from the
discharge zone .
12. Never attempt to unclog the outlet or
discharge opening while the engine is