Product Manual

problems are detected.
Replacing Power Belt
1.Stop the engine, di
sconnect the spark
plug and check that the engine has
stopped completely.
2.Remove the bolts holding the belt guard
and remove.
3.Loosen the bolts holding the engine at its
base.
4.Adjust belt tension by loosening the
tensioner bolt, use a 1/2
" hex wrench.
5.Proceed to replace and adjust tension
again until it is felt tight by pressing down
with the finger.
6.Assemble
the belt guard in the same way
it was disassembled.
Cleaning of the equipment
Carefully clean the cut
ting chamber after
each use.
WARNING
The rotor blade is sharp.
Wear
leather gloves to protect your
hands when cleaning the cutting
chamber.
NOTE:
Blasting pressurized water
chamber is not recommended.
Taking care of your engine
NOTE: Review the sectio
ns of maintenance
and operation of the engine manual for
detailed instructions.
1. Check the oil level.
2. Clean the engine regularly with a
cloth or brush. Keep clean the air
intake system to allow proper air
circulation. Remove all grass, dirt
and combustible debris from muffler
area.
sconnect the spark
plug and check that the engine has
2.Remove the bolts holding the belt guard
3.Loosen the bolts holding the engine at its
4.Adjust belt tension by loosening the
" hex wrench.
5.Proceed to replace and adjust tension
again until it is felt tight by pressing down
the belt guard in the same way
Cleaning of the equipment
ting chamber after
Wear
leather gloves to protect your
hands when cleaning the cutting
Blasting pressurized water
into the
Taking care of your engine
ns of maintenance
and operation of the engine manual for
2. Clean the engine regularly with a
cloth or brush. Keep clean the air
intake system to allow proper air
circulation. Remove all grass, dirt
and combustible debris from muffler
SERVICING
YOUR WOODCHIPPER
Rotor Blade
WARNING
The rotor blade is sharp.
leather gloves to protect your
hands when the cleaning cutting
chamber.
Blade re-sharpening
1. Stop the engine, disconnect
plug and check that the rotor of the chipper
has stopped completely.
2. Open chipper by
loosening the lock knob.
3. Remove the bolts securing the blade to
the rotor using a 5mm Allen key and a 9/16”
hex wrench on the opposit
e
4. Remove the blade and proceed
change or resharpen
blade
5. Blade must be sharped at a 30deg. angle
and must not overheat to loose its heat
treatment properties.
6. Tighten the bolts again.
NOTE: To remove the
bolts from the blade
is recomme
nded to place a piece of wood
in between the rotor and the outside edge
to lock it, preventing
it from rotating when
loosening the bolts.
Anvil sharpening or adjustment
1. Loosen the bolts from under the anvil
bed. Use a 9/16 "Hex Wrench and
5mm Allen key.
2. Between the blade and the anvil,
15
YOUR WOODCHIPPER
The rotor blade is sharp.
Wear
leather gloves to protect your
hands when the cleaning cutting
1. Stop the engine, disconnect
the spark
plug and check that the rotor of the chipper
loosening the lock knob.
3. Remove the bolts securing the blade to
the rotor using a 5mm Allen key and a 9/16”
e
side.
4. Remove the blade and proceed
to
blade
.
5. Blade must be sharped at a 30deg. angle
and must not overheat to loose its heat
bolts from the blade
, it
nded to place a piece of wood
in between the rotor and the outside edge
it from rotating when
Anvil sharpening or adjustment
1. Loosen the bolts from under the anvil
bed. Use a 9/16 "Hex Wrench and
2. Between the blade and the anvil,